+86-510-88996388
enLanguage
Home / Knowledge / Details

Dec 03, 2022

The difference between shallow air flotation machine and dissolved air flotation machine installation

1. When the dissolved air flotation machine is installed, because the equipment is still and the water moves, the pool depth is generally 2.0~2.5m. After the water enters the contact area from the reverberation chamber, the flow direction changes and the flow velocity is redistributed, that is to say, the water flow is converted into an average upward movement. It takes a certain time and height to complete this change, and its height is not low, which can reach 1.5 m.

The shallow air flotation uses the "zero speed" principle to complete the mobile device, the water body is still, and the influence of the water body disturbance on the separation of suspended particles is eliminated. And the height requirement is reduced. During the installation process of the dissolved air flotation machine, it is inevitable that sediment or flocs will sink to the bottom of the tank. The outlet pipe is generally suspended at a height of 300mm to avoid silt at the bottom of the pool.

2. Buoyancy device

In the shallow air flotation device, since the mud scraper is located at the bottom of the pool, there is no need to set up a hanging section.

3. When installing the dissolved air flotation machine, the residence time of the water body is generally controlled at 10 to 20 minutes; the residence time on the shallow air flotation device is only 4 to 6 minutes.

4. When installing the dissolved air flotation machine, a dissolved air tank is installed in the dissolved air system. If calculated based on the actual volume of the dissolved air tank, the hydraulic retention time is 2 to 4 minutes;

5. In the shallow sea flotation device, the gas-liquid system adopts the gas-dissolving tube to remove the filler, the volume utilization rate reaches 100%, and the hydraulic retention time is only 10-15s.

It is greatly disturbed, and the scum layer is also greatly disturbed. High moisture content;

In the shallow air flotation equipment, the spiral skimmer is installed in front of the water supply equipment, and the scum discharged from the air flotation tank is always long (4-6 minutes), that is, the solid-liquid separation is complete and the water content is low.


Send Message