How to improve the working efficiency of shallow air flotation?

1. Before applying the shallow air flotation equipment, it is necessary to check the switching power supply line of the equipment and do a short-term full-load operation. In order to distinguish whether the conversion of the pump and the air compressor is appropriate, whether there is noise and heat, the mixer introduces cold water Touch the device to determine whether the conversion is appropriate.
2. When we use the equipment, we also need to pay special attention to the sludge collection and deceleration machine of the equipment to see whether its rotation is correct, whether there are any shocks and instability, remove them in time, and open the dissolving medicine machine. Configure the power switch according to the concentration of the liquid medicine, stir until the concentration of the liquid medicine is uniform, clean the air flotation machine without leaving dirt, check whether the connection position is loose, and the introduction of grease at the rotating position.
3. Everyone needs to remove the sludge from the slag scraper on time and establish scraping rules and regulations that are realistic . It should be noted that during the process of using the shallow air flotation equipment, we also need to ensure that the water level of the air flotation does not engulf the filling layer, nor is it less than 0.6m. This is to avoid a large amount of air flotation in the middle. Undissolved gas will affect the effect.